DHCP-Related Error Messages
Error messages related to DHCP and the integrated Ethernet controller are shown in
the following table. Each error message consists of an error code followed by a text
message.
If you encounter one of these error messages, record the message, and contact your
network administrator.
Note: Any x value that follows an error code represents any alphanumeric
character.
E61: Service boot cancelled. M38: Cannot open TFTP connection.
E62: Cannot initialize controller. M39: Cannot read from TFTP connection.
E63: Cannot initialize controller. M40: BOOTP cancelled by keystroke.
E67: Cannot initialize controller. M40: DHCP cancelled by keystroke.
E6d: Cannot find BOOTP server. M41: BOOTP timeout.
E6e: Cannot start from downloaded image. M41: DHCP timeout.
E71: Too many MTFTP packages. M42: No client or server IP.
M10: ARP cancelled by keystroke. M43: No bootfile name.
M11: ARP timeout. M44: Cannot ARP redirected BOOTP server.
M20: Cannot copy memory. M6f: System is locked! Press Ctrl+Alt+Del to reboot.
M21: Cannot write to memory. M90: Cannot initialized controller for multicast.
M22: Cannot write to memory. M91: MTFTP cancelled by keystroke.
M30: Cannot ARP TFTP address. M92: MTFTP open timeout.
M31: TFTP cancelled by keystroke. M93: Unknown MTFTP opcode.
M32: TFTP open timeout. M94: MTFTP read cancelled by keystroke.
M33: Unknown TFTP opcode. M95: MTFTP timeout.
M34: TFTP read cancelled by keystroke. M96: Cannot ARP MTFTP address.
M35: TFTP timeout. M98: Cannot open MTFTP connection.
M99: Cannot read from MTFTP connection. Txx: <message from TFTP error packet>
108 Using Your Personal Computer
To Next Page
Loading...
Need help?
General