Exiting from the Configuration/Setup Utility Program
When you finish viewing or changing settings in the Configuration/Setup Utility
program, follow these steps to exit from the program:
1. Press Esc until you return to the Configuration/Setup Utility program menu.
2. Do one of the following:
a. To restore the settings before they were changed and saved, select Restore
Settings.
b. To load the default values for all settings, select Load Default Settings.
8
c. To save any changed settings (including restored settings or default
settings), select Save Settings. If you do not save settings here, you are
given the opportunity to do so in the Exit Setup menu.
3. Press Esc to enter the Exit Setup menu and follow the instructions on the screen.
8
If you are a network administrator using RPL or DHCP in conjunction with network-management
software, read “Network-Enabled Startup Sequence” on page 66 before loading the default settings.
Chapter 5. Using the Configuration/Setup Utility Program
43
To Next Page
Loading...
Need help?
General