POST Message Description
604 A failure occurred during the testing of a diskette drive.
Action:
1. Verify that the Configuration/Setup Utility program correctly reflects
the type of diskette drive you have installed. (For instructions on
using the Configuration/Setup Utility program, refer to Chapter 5,
“Using the Configuration/Setup Utility Program” on page 39.)
2. Run the diagnostic programs. (See “Diagnostic Programs” on page 104
for information about diagnostic programs provided with your
computer.)
3. If the diagnostic programs detect a failure, replace the diskette drive.
If the problem cannot be isolated and corrected, have the computer
serviced.
662 A diskette drive configuration error occurred.
Action:
1. Verify that the Configuration/Setup Utility program correctly reflects
the number of diskette drives you have installed. (For instructions on
using the Configuration/Setup Utility program, refer to Chapter 5,
“Using the Configuration/Setup Utility Program” on page 39.)
2. If you installed or removed a diskette drive, you must save the new
configuration in the Configuration/Setup Utility program. Refer to
page 44 for further information and instructions on saving the
configuration.
If this does not correct the problem, have the computer serviced.
Chapter 6. Solving Problems 81
To Next Page
Loading...
Need help?
General