Select this choice to view or change the start options, including the startup
sequence, keyboard NumLock state, PXE boot option, and PCI device boot
priority. Changes in the startup options take effect when you start the server.
The startup sequence specifies the order in which the server checks devices to
find a boot record. The server starts from the first boot record that it finds. If the
server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that
checks for a disc in the CD-RW/DVD drive, then checks the hard disk drive,
and then checks a network adapter.
This choice is on the full Setup utility menu only.
v Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot
from a file, select a one-time boot, or reset the boot order to the default setting.
v System Event Logs
Select this choice to enter the System Event Manager, where you can view the
POST event log and the system-event log. You can use the arrow keys to move
between pages in the error log.
The POST event log contains the three most recent error codes and messages
that were generated during POST.
The system-event log contains POST and system management interrupt (SMI)
events and all events that are generated by the baseboard management
controller that is embedded in the integrated management module (IMM).
Important: If the system-error LED on the front of the server is lit but there are
no other error indications, clear the system-event log. Also, after you complete a
repair or correct an error, clear the system-event log to turn off the system-error
LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST event log.
– System Event Log
Select this choice to view the system event log.
– Clear System Event Log
Select this choice to clear the system event log.
v User Security
Select this choice to set, change, or clear passwords. See “Passwords” on page
121 for more information.
This choice is on the full and limited Setup utility menu.
– Power-on Password
Select this choice to set or change a power-on password. See “Power-on
password” on page 121 for more information.
– Administrator Password
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is
set, the full Setup utility menu is available only if you type the administrator
password at the password prompt. For more information, see “Administrator
password” on page 122.
v Save Settings
Select this choice to save the changes that you have made in the settings.
v Restore Settings
120 System x3300 M4 Type 7382: Installation and Service Guide
To Next Page
Loading...
Need help?
General