9. Make sure that the battery holder is secured firmly.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 104.
Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Installing drives
The followings are illustrations of the server and the location of the drive bays.
Your hardware might differ, depending on the model.
Note: If the server is configured for RAID operation using a ServeRAID adapter,
you might have to reconfigure your disk arrays after you install drives. See the
ServeRAID adapter documentation for additional information about RAID
operation and complete instructions for using the ServeRAID adapter.
The following illustrations show the location of the drive bays in the 2.5-inch and
3.5-inch hard disk drive server models.
v The server with eight 2.5-inch hard disk drives:
Chapter 6. Removing and replacing components 339
To Next Page
Loading...
