IBM System x3300 M4 User Manual

Configuring RAID arrays
Use the configuration utility programs to configure and manage redundant array
of independent disks (RAID) arrays. Be sure to use this program as described in
this document.
The following table lists the different server configurations and the applications
that are available for configuring and managing RAID arrays.
Table 16. Server configuration and applications for configuring and managing RAID arrays
Server configuration
RAID array configuration
(before operating system is
installed)
RAID array management
(after operating system is
installed)
ServeRAID-H1110 adapter LSI Utility (Setup utility,
press Ctrl+C), ServerGuide,
Human Interface
Infrastructure (HII)
MegaRAID Storage Manager
(MSM), SAS2IRCU
(Command Line) Utility for
Storage Management
ServeRAID-M1115 adapter MegaRAID BIOS
Configuration Utility (press
Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start),
ServerGuide, HII
MegaRAID Storage Manager
(MSM), MegaCLI (Command
Line Interface), and IBM
Director
ServeRAID-M5110,
ServeRAID-M5120 adapters
MegaRAID BIOS
Configuration Utility (press
Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start),
ServerGuide, HII
MegaRAID Storage Manager
(MSM), MegaCLI, and IBM
Director
ServeRAID-C105 HII MegaRAID Storage Manager
(MSM), MegaCLI
Note:
1. For more information about Problem Determination and Service Guide for
ServeRAID M controllers, see http://www-947.ibm.com/support/entry/
portal/docdisplay?lndocid=MIGR-5085607.
2. For more information about Configuration and Options Guide (COG), see
http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=SCOD-
3ZVQ5W&brandind=5000019.
3. For further details on creating a software RAID array of hard disk drives,
please see the ServeRAID C105 documentation at http://www-947.ibm.com/
support/entry/portal/docdisplay?lndocid=SERV-RAID.
128 System x3300 M4 Type 7382: Installation and Service Guide

IBM System x3300 M4 Specifications

General

Brand	IBM
Model	System x3300 M4
Category	Server
Language	English