2. Turn off the server (see “Turning off the server” on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Carefully turn the server on its side so that it is lying flat, with the left-side
cover facing up.
4. Unlock the left-side cover, using the key that comes with the server.
5. Pull the rear edge of the left-side cover backward to remove the left-sdie cover
away from the server.
Installing the left-side cover
To install the server cover, complete the following steps:
1. Read the safety information that begins in Safety and “Installation guidelines”
on page 36.
2. Turn off the server (see “Turning off the server” on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Slide the left-side cover over the server until the left-side cover edges slip into
position over the chassis.
Important: Before you slide the left-side cover forward, make sure that all the
tabs on the cover engage the chassis correctly. If all the tabs do not engage the
chassis correctly, it will be hard to remove the cover later.
4. Lock the left-side cover, using the key that comes with the server.
Chapter 6. Removing and replacing components 333
To Next Page
Loading...
Need help?
General