8. Remove the system battery:
a. If there is a rubber cover on the battery holder, use your fingers to lift the
battery cover from the battery connector.
b. Use one finger to tilt the battery horizontally out of its socket, pushing it
away from the socket.
Attention: Neither tilt nor push the battery by using excessive force.
c. Use your thumb and index finger to lift the battery from the socket.
Attention: Do not lift the battery by using excessive force. Failing to
remove the battery properly may damage the socket on the system board.
Any damage to the socket may require replacing the system board.
9. Insert the new battery:
a. Position the battery so that the positive (+) symbol is facing you.
b. Place the battery into its socket until it clicks into place. Make sure that the
battery clip holds the battery securely.
10. Install the cover (see “Installing the left-side cover” on page 108).
11. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Note: You must wait approximately 3 minutes after you connect the server
power cord to an electrical outlet before the power-control button becomes
active.
12. Start the Setup utility and reset the configuration:
a. Set the system date and time.
b. Set the power-on password.
c. Re-configure the server.
See “Starting the Setup utility” on page 116
13. Dispose of the battery as required by local ordinances or regulations. See the
IBM Environmental Notices and User's Guide on the IBM Documentation CD for
more information.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 104.
Chapter 6. Removing and replacing components 379
To Next Page
Loading...
Need help?
General