Using a Supervisor Password
Setting a Supervisor Password when Using Several Hard Disk
Drives:
To set a supervisor password when using more than one hard disk
drive on your computer:
To set a supervisor password:
Page 110.
1
Set a supervisor password on your computer.
To install the hard disk drive:
Page 132.
2
Install the hard disk drive that you want to set the supervisor
password for, in the main hard disk drive bay (to the right of
the battery pack).
3
Turn on the computer. A 158 error appears.
4
Press Enter.
5
Type your supervisor password at the power-on password
prompt.
If an error code 158 appears, press Enter to go to the
Easy-Setup password screen.
6
Select the Supervisor icon; then press Enter.
The supervisor password sets the hard disk password on the
hard disk drive.
7
Turn off the computer. Repeat steps 2 through 7 to set the
supervisor password for each hard disk drive.
114 IBM ThinkPad 760E, 760ED, or 760EL User's Guide
To Next Page
Loading...
