IBM ThinkPad 760E - Installing the Thinkpad Features Program for OS; 2

Installing OS/2 Software
Have the diskettes that came with the OS/2 system ready; then
install the CD-ROM device driver for OS/2:
1 Start OS/2 Warp; then open OS/2 System, System Setup, and
then Selective Install.
2 Select the CD-ROM Device Support icon.
3 Select Non-listed IDE CD-ROM and click on OK.
4 Click on OK at the System Configuration screen.
5 At the OS/2 Setup and Configuration screen, select Install; then
follow the instructions on the screen.
For information about the software parameter in the CONFIG.SYS
file, refer to the README file in the CD-ROM Driver Diskette.
Installing the ThinkPad Features Program for OS/2
To install the ThinkPad Features program:
1 Start OS/2 Warp; then insert the Utility Diskette for OS/2 into
the diskette drive.
2 Install the ThinkPad System Management device driver:
a) Open OS/2 System and then System Setup.
b) Select Device Driver Install and click on the Install...
button.
c) Click on ThinkPad System Management Device Driver;
then click on OK.
3 Open the OS/2 screen command prompt.
4 Go to the A: prompt and type INSTALL2; then press Enter.
Follow the instructions on the screen.
5 Install the Windows ThinkPad Features program for the
WIN-OS/2 session:
a) Exit the OS/2 screen; then open a WIN-OS/2 full screen.
b) Follow the instructions in “Installing the ThinkPad Features
Program for Windows 3.11” on page 194.
Chapter 7. Installing Software 177