IBM ThinkPad 760E - Installing the Enhanced Video; M PEG Device Driver for OS; 2

Installing OS/2 Software
To install the ThinkPad display device driver:
1 Start OS/2 Warp.
2 Insert the Video Features Diskette for OS/2 into the diskette
drive and open the OS/2 full screen or OS/2 window.
3 Go to the A: prompt; then type INSTALL and press Enter.
Follow the instructions on the screen.
4 After the installation is complete, remove the diskette, shut
down OS/2, and restart the computer.
Installing the Enhanced Video/MPEG Device Driver for OS/2
760
E
V
ideo
nh
This section is for computers with the Enhanced Video/MPEG
features installed.
Important
To use the Video Overlay/Capture and MPEG functions, make
sure you have installed the following software before installing
the Video Overlay/Capture and MPEG device drivers:
ThinkPad Display Driver (9385) for OS/2 Warp
Mwave DSP support software
Video IN from the OS/2 BonusPak preloaded on the
computer
Installing the MMPM/2 MPEG Update Diskette
Important
This procedure is necessary only for OS/2 Warp Version 3 and
3.01. For versions of OS/2 Warp later than that, skip this
section.
Chapter 7. Installing Software 183