Installing Windows 3.11 Software
Installing the ThinkPad Display Driver for Windows 3.11
Note:
When installing an operating system,
you need to install the ThinkPad
display driver.
Do the following to install the ThinkPad display driver for Windows
3.11 so that you can get a correct display setting and a better
performance:
1
Start DOS; then go to the WINDOWS subdirectory.
Note:
You can change the display
resolution type by using the
ThinkPad Features program after
completing the installation of the
ThinkPad Features program for
Windows.
2
Type SETUP to start the Windows setup program.
3
Using the Up Arrow ( ), highlight Display and press Enter.
4
Select Other (Requires disk...) from the list.
5
Insert the Video Features Diskette for Windows into the
diskette drive; then type A: and press Enter.
6
Select your desired resolution from the menu and press Enter.
Verify that Display has changed to your desired resolution type
(an example is shown in the following screen). If the item has
not changed, return to step 3.
Note:
Cyber
xxxx
in the right screen
means:
For the TFT model: Cyber9385
For the DSTN model: Cyber9320
Windows Setup
===============
Setup has determined that your system includes the following hardware
and software components. If your computer or network appears on the
Hardware Compatibility List with an asterisk, press F1 for Help.
Computer: MS-DOS System with APM
Display: Cyberxxxx 1 24×768 256 small font
Mouse: Microsoft, or IBM PS/2
7
Press Enter to continue the installation.
8
After the installation is complete, remove any diskette from the
diskette drive and restart the computer.
Chapter 7. Installing Software 193
To Next Page
Loading...
Need help?
General