Installing DOS Software
Installing the PC Card Director for DOS
PC Card Director:
Page 44.
Note:
Do not install the Phoenix
**
PCMCIA
support in IBM PC DOS 7.0.
When installing DOS, you need to install the following software to
use the PC Cards:
PC Card device drivers:
– Card Services device driver
– Socket Services device driver
– Resource Map Utility device driver
– PC Card Power Management device driver
– PC Card Director utility
Note:
The PC Card client device driver is
not part of the preloaded software.
Refer to the manual that came with
the PC Card to install the device
driver.
PC Card client device drivers (only when PC Card Director does
not support the PC Card)
To install the PC Card Director:
1
Start DOS.
2
Insert the PC Card Director Diskette for DOS and Windows into
the diskette drive; then type A: and press Enter.
3
Type PCMINSTD; then press Enter.
4
Follow the instructions on the screen.
Default choices are already highlighted at the Selector screens.
Note:
Whenever you update the
CONFIG.SYS file, see page 279.
5
After the installation is complete, remove any diskette from the
diskette drive and restart the computer.
188
IBM ThinkPad 760E, 760ED, or 760EL User's Guide
To Next Page
Loading...
Need help?
General