Installing Windows 95 Software
Installing the Mwave DSP Support Software for Windows 95
760
M
wave
Do one of the following:
If you are installing the Mwave DSP support software for
Windows for the first time,
you need to install Mwave DSP
support software for Windows 95 and MIDI sample files.
If you have already installed the Mwave DSP support software
for Windows,
you need to install only the Mwave DSP support
software. You do not need to install the MIDI sample files.
Installing the Mwave DSP Support Software
To install the Mwave DSP support software:
1
Start Windows 95; then click on Start, and then Run....
2
Insert the Mwave DSP Features Diskette 1 for Windows 95 into
the diskette drive; then type A:SETUP and press Enter.
The Mwave installation window appears and prompts you to
input the destination directory for the software. If the default
directory is OK, press Enter. Otherwise, type a directory name
and press Enter.
Follow the instructions on the screen.
3
If you are installing the Mwave DSP support software for the
first time, go to “Installing the Mwave MIDI Sample Files” on
page 208 and follow the instructions. Otherwise, remove any
diskette from the diskette drive and restart Windows 95.
Note
Non-U.S. users must run the Country Selection program in the
Mwave window after the Mwave installation is complete. Restart
the computer after you run Country Selection.
Chapter 7. Installing Software 207
To Next Page
Loading...
Need help?
General