IBM ThinkPad 760E - Installing IBM OS; 2 Warp Version 3

Installing OS/2 Software
3 Delete the file SONY31A.ADD from the backup copy
diskette.
4 Install OS/2 Warp using the backup copy diskette you have
just created.
Installing IBM OS/2 Warp Version 3
Your installation of OS/2 Warp will differ, depending on whether you
use the
Dual Boot or the Boot Manager for switching between OS/2
Warp and DOS/Windows.
Which type are you going to use?
Dual Boot Go to page 170.
Boot Manager Go to page 171.
Avoiding Video Problems for OS/2 Warp
If you have a video problem, such as a screen blackout, when
installing OS/2 Warp, go to page 175 to solve the problem.
Installing OS/2 Warp with Dual Boot
To install the DOS ThinkPad
Features program:
Page 187.
To install the Windows ThinkPad
Features program:
Page 194.
Install DOS, Windows, and their ThinkPad Features program before
installing OS/2 Warp.
To install OS/2 Warp:
To install the diskette version of OS/2 Warp, refer to the
OS/2 documentation; however, pay attention to the following
during installation:
– Select VGA as the Primary Display in the System
Configuration screen.
– Select No Support Installed, not PCMCIA Feature, at
the System Configuration screen.
Note:
If you have the OS/2 Warp FixPak
10 (XR0010) or later, install it after
you complete the installation of OS/2
Warp. Follow the instructions in the
README.1ST file in diskette 1 of
that FixPak.
170 IBM ThinkPad 760E, 760ED, or 760EL User's Guide