Installing Windows 3.11 Software
4
Follow the instructions on the screen to complete the
installation.
Default choices are already highlighted at the choice screens.
5
After the installation is complete, remove any diskette from the
diskette drive and restart the computer.
Installing the Mwave DSP Support Software for Windows 3.11
760
M
wave
Attention:
Before you install the Mwave DSP
support software, close all open
applications.
To install the Mwave DSP support software:
1
Start Windows.
2
Select File from the Program Manager window; then select
Run... from the pull-down menu.
3
Insert the Mwave DSP Features Diskette 1 for Windows into
the diskette drive; then type A:SETUP and press Enter.
4
Follow the instructions on the screen.
Default choices are already highlighted at the choice screens.
Note:
When installing an operating system,
you need to install the Mwave DSP
support software.
5
After the installation is complete, remove any diskette from the
diskette drive and restart the computer.
Note
Non-U.S. users must run the Country Selection program in
the Mwave window after the Mwave installation is complete.
Restart the computer after you run Country Selection.
If this is your first time to install the Mwave DSP support software for
Windows, also install the MIDI sample files as follows:
6
Follow the same procedures from step 2 to step 5; however,
use the MIDI Samples Diskette 1 instead of the Mwave DSP
Features Diskette 1 for Windows.
7
After the installation is complete, remove any diskette from the
diskette drive and restart the computer.
Chapter 7. Installing Software 195
To Next Page
Loading...
Need help?
General