IBM TS1160

Force Error Dump…
Use this only when directed by your next level of support. Aborts the operation, causes a recovery of
the functional microcode, and forces a microcode dump. After the dump is completed, select Reset
Drive.
Choosing Reset Drive or Force Error Dump causes the menu that is shown in Figure 46 on page 99 to
display.
ARE YOU SURE? |
►CANCEL |
PROCEED | Will abort jobs
Figure 46: Conrmation menu
Cancel
Causes the microcode to ignore the selection and causes the Services menu to display.
Proceed
Causes the microcode to complete the chosen operation (Reset Drive or Force Error Dump) from the
Services menu.
Set Online menu
Table 53 on page 99 shows the Set Online menu items.
Table 53:
Set Online menu
Function Next menu
Cancel “Services menu” on page 97
Port 0 “Options menu” on page 97
Port 1 “Options menu” on page 97
Both “Options menu” on page 97
Cancel
Causes the “Services menu” on page 97 to display.
Port 0
Causes Fibre Port 0 to be set online.
Port 1
Causes Fibre Port 1 to be set online.
Both
Causes both Fibre Port 0 and Fibre Port 1 to be set online.
Note: The host also must vary the device online.
Set Offline menu
Table 54 on page 99 shows the Set Offline menu items.
Table 54:
Set Offline menu
Function Next menu
Cancel “Services menu” on page 97
Port 0 “Conrm Offline menu” on page 100 or “Options menu” on page 97
Virtual Operator panel 99