Important: 60F is capable of N-Port ONLY.
Cancel
Causes “Set Port 0 {or 1} menu (Services menu)” on page 101 to display.
L-Port
Allows CE to set port as an L-Port. This option must be selected if the drive is attached to a supported
tape controller.
N-Port
Allows CE to set port as an N-Port.
L -> N Negotiate
Allows CE to set port to negotiate port setting: L rst, then N (default).
N -> L Negotiate
Allows CE to set port to negotiate port setting: N rst, then L. Select L -> N Negotiate if you are
uncertain.
CE Save Data menu (Speed and Topology)
Table 61 on page 104 shows the Save Data menu items. This menu allows the CE to save or decline
saving the data that was entered at the previous menu.
Table 61: CE Save Data menu (Speed and Topology)
Function Next menu
Cancel Previous menu
Yes Previous menu
No Previous menu
Cancel
Displays the previous menu that was active before Save Data was selected.
Yes
Causes the Set Port 0 {or 1} Speed and Topology settings to be saved.
No
Prevents the Set Port 0 {or 1} Speed and Topology settings from being saved.
Set Hard Address menu
Table 62 on page 104 shows the Set Hard Address menu items.
Table 62:
Set Hard Address menu
Function Next menu
Cancel “Set Port 0 {or 1} menu (Services menu)” on page 101
c -
d -
Save Data “Set Port 0 {or 1} menu (Services menu)” on page 101
104 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
To Next Page
Loading...
Need help?
General