Java and all Java-based trademarks and logos are trademarks or registered trademarks of Oracle or its
afliates.
Cell Broadband Engine is a trademark of Sony Computer Entertainment, Inc. in the United States, other
countries, or both and is used under license therefrom.
Linear Tape-Open, LTO, the LTO Logo, Ultrium, and the Ultrium logo are trademarks of HP, IBM Corp., and
Quantum in the US and other countries.
Symbols
The following symbols are used in this manual.
Symbol
Description
Displays on the service panel to indicate that the device requires service if the processor Check LED is
on. Also imprinted on the Change Mode button to allow the CE to change among the Operator mode,
the CE Offline mode, and the CE Online mode.
Displays on the service panel to indicate that trace data is stored in the device. Also printed in text as
an Attention notice.
Displays on the service panel when flash dump trace data is available in flash memory.
Printed in text and in gures to indicate an ESD-sensitive part.
Printed in text and in gures to indicate that a Class I Laser device is installed.
Displays on the service panel to indicate that the slide bar on the cartridge is set to the le-protected
position.
Displays on the service panel to indicate that the host le-protected the volume.
Displays on the service panel to indicate that the slide bar on the cartridge is set to the not le-
protected position.
Compliance statements
Some of these statements can apply to your installation.
Canada Notice
CAN ICES-3 (A)/NMB-3(A)
Avis de conformité à la réglementation d'Industrie Canada
Cet appareil numérique de la classe A est conform à la norme NMB-003 du Canada.
Appendix E. Notices
291
To Next Page
Loading...
Need help?
General