44
7 DV MODE OPERATION (Optional UT-121 is required for IC-91A)
DD
Repeater operation into another zone
qSet the desired repeater’s frequency, offset and shift direc-
tion in B band.
(pgs. 18, 31)
• Select DV mode in advance.
wSet your own call sign. (p. 38)
• See p. 34 for your own call sign programming.
eSet the desired station call sign. (p. 39)
• When making a CQ call
Set the desired repeater’s
(in a different zone) call sign with
a “/” symbol at the 1st digit, for the area in which you
want to make a CQ call, into “UR.”
• See p. 36 for station call sign programming.
rSet the repeater’s call sign as follows;
zEnter “R1” in call sign set mode.
xRotate [DIAL]
†
to select the nearest repeater’s call sign.
• If the nearest repeater is gateway repeater, select the re-
peater’s call sign with “G” setting at the 8th digit.
cPush [ï](5) to set the call sign for “R1.”
• Return to CALL SIGN screen.
vRotate [DIAL]
†
to select “R2” then push [ï](5)
†
.
bRotate [DIAL]
†
to select the gateway repeater’s (in the
same zone) call sign.
• The call sign should have “G” setting at the 8th digit.
• When gateway repeater call sign is set in “R1,” select “NOT
USE✱” for “R2” setting.
nPush [ï](5) to set the call sign for “R2.”
• Return to CALL SIGN screen.
mPush [MENU/LOCK] to return to frequency indication.
tPush [PTT] to transmit; release to receive.
To Next Page
Loading...
Need help?
General
