Icom IC-91A - Priority Watch Operation

■ Priority watch operation
DD
Memory/call channel and memory scan watch
qSelect VFO mode; then, set an operating frequency.
wSet the watching channel(s).
For memory channel watch:
Select the desired memory channel.
For call channel watch:
Select the desired call channel.
For memory scan watch:
Select memory mode, or the desired bank group; then,
push and hold [SCAN](2) for 1 sec. to start memory/bank
scan.
eEnter “PRIO WATCH” in scan set mode.
(p. 96)
r Rotate [DIAL]
†
to select “ON.”
• Select “BELL” if the priority beep function is desired.
t Push [MENU/LOCK] to exit scan set mode and start the
watch.
•“PRIO” indicator appears.
• The transceiver checks the memory/bank channel(s) or call
channel every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 81)
y Push [VFO] to cancel the watch.
• During priority watch
Monitors VFO frequency
for 5 sec.
Pauses on a memory or
call channel when a sig-
nal is received.
• During priority watch with priority beep
Emits beep and blinks “S” indicator when a signal is re-
ceived on a memory or call channel.
PRIOPRIOFMFM
A
145 180
µ
035035
PRIOPRIOFMFM
A
433 260
P SKIPSKIP
PRIOPRIOFMFM
A
145 180
µ
035035
PRIOPRIOFMFM
A
433 260
P SKIPSKIP
MENU screen ➪ SCAN ➪ PRIO WATCH
(Push [MENU/LOCK]) (Rotate [DIAL]
†
, then push [ï](5)
†
.)
Although [DIAL] and [ï](5) are used for description in this
section, [
∫∫
](2)/[
√√
](8) and [
≈≈
](6) are available instead of
[DIAL] and [ï](5).
83
10
PRIORITY WATCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
†
[DIAL] ↔ [
∫∫
](2)/[
√√
](8) [ï](5) ↔ [
≈≈
](6)