Icom IC-91A - VFO Scan Watch Function

84
10 PRIORITY WATCH
DD
VFO scan watch
qSet the watching channel(s).
For memory channel watch:
Select the desired memory channel.
For call channel watch:
Select the desired call channel.
For memory scan watch:
Select memory mode, or the desired bank group; then,
push and hold [SCAN](2) for 1 sec. to start memory/bank
scan.
wEnter “PRIO WATCH” in scan set mode.
(p. 96)
e Rotate [DIAL]
†
to select “ON.”
• Select “BELL” if the priority beep function is desired.
r Push [VFO] to exit scan set mode and start the watch.
•“PRIO” indicator appears.
tPush and hold [SCAN](2) for 1 sec. to enter scan type se-
lection condition.
yRotate [DIAL] to select the desired scan type from “ALL,”
“BAND” and “PROG-xx
(xx= 0–24),” “DUP.”
uRelease [SCAN](2) to start the VFO scan watch.
• The transceiver checks the memory/bank channel(s) or call
channel every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 81)
i Push [VFO] to cancel the watch.
• During priority watch
Searches VFO frequencies
for 5 sec.
Pauses on a memory or
call channel when a sig-
nal is received.
• During priority watch with priority beep
Emits beep and blinks “S” indicator when a signal is re-
ceived on a memory or call channel.
PRIOPRIOFMFM
A
145 000
µ
000000
PRIOPRIOFMFM
A
888800
P SKIPSKIP
PRIOPRIOFMFM
A
145 000
µ
000000
PRIOPRIOFMFM
A
888800
P SKIPSKIP
MENU screen ➪ SCAN ➪ PRIO WATCH
(Push [MENU/LOCK]) (Rotate [DIAL]
†
, then push [ï](5)
†
.)
†
[DIAL] ↔ [
∫∫
](2)/[
√√
](8) [ï](5) ↔ [
≈≈
](6)