52
7 DV MODE OPERATION (Optional UT-121 is required for IC-91A)
■ Message operation
DD
TX message programming
TX messages are available for up to 5 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are 0 to 9, A to Z
(capital let-
ters), a to z (lower case letters), some symbols and space.
qEnter “TX MESSAGE” in message/position set mode.
• TX MESSAGE screen is displayed.
wRotate [DIAL]
†
to select the desired transmit message
channel.
• Ch01 to Ch05 and OFF are available.
• Previously message is displayed if programmed.
ePush [
≈≈
](6) to select the message edit condition.
• The 1st digit of the message blinks.
rRotate [DIAL]
†
to select the desired character or symbol.
• Push [A/a](3) to change the character group from “AB” (alpha-
betical characters; capital letters), “ab” (alphabetical characters;
lower case letters), “12” (numbers) and “ !”” (symbols) in se-
quence.
• If an un-necessary character is entered, push [
≈≈
](6) or [
ΩΩ
](4) to
select the character, then push [CLR](1) to erase the selected
character, or push and hold [CLR](1) for 1 sec. to erase all char-
acters following the cursor.
tPush [
≈≈
](6) to select 2nd digit, then rotate [DIAL]
†
to select
the desired character or code.
• Push [
≈≈
](6) to move the cursor right; push [
ΩΩ
](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
yRepeat the steps r and t to enter the desired message.
• Up to 20-character messages can be set.
uPush [ï](5) to store the message.
iPush [MENU/LOCK] to return to frequency indication.
To Next Page
Loading...
