Icom IC-M604 - 6 Dsc Operation; MMSI Code ProgrammNg; DSC Address ID

16
DSC OPERATION
6
■ MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
This code programming can be performed only twice.
q While pushing and holding [MENU], push [POWER] to
enter MMSI code programming condition.
• Turn power OFF in advance.
w After the display appears, release [MENU].
e Enter “MMSI check” in DSC Set up menu.
DSC Menu ➪ Set up ➪ MMSI Check
(Push [MENU]) (Rotate [SELECTOR], then push [ENT].)
r Edit the specific MMSI code directly with the keypad.
• Rotate [SELECTOR] to move the cursor backward or forward.
--DSC Menu--
MMSI Check
_________
<CLR˘Exit / ENT˘OK>
t After entering the 9-digit code, push [ENT] to set the code.
• Returns to the DSC set up menu.
y Push [CLR] or rotate [SELECTOR] to select “Exit,”
push [ENT] to return to DSC menu.
• Repeat again to return to the normal operation condition.
■ DSC address ID
A total of 100 DSC address IDs can be programmed and
named with up to 10 characters.
D Programming Individual ID
q Enter “Add:INDV ID” in DSC Set up menu.
DSC Menu ➪ Set up ➪ Add:INDV ID
(Push [MENU]) (Rotate [SELECTOR], then push [ENT].)
w Set the individual ID and ID name directly with the key-
pad.
• Edit the 9-digits of the appropriate distress ID directly with the
keypad.
• Rotate [SELECTOR] to move the cursor backward or forward.
• Push [CE] to clear the ID and name.
• Push [CLR] to cancel and exit the condition.
--DSC Menu--
Add:Individual ID
Input 9 digits
_________
Input name
_________
<CLR˘Exit / ENT˘OK>
e Push [ENT] to program and return to the DSC set up
menu.
r Push [CLR] or rotate [SELECTOR] to select “Exit,”
push [ENT] to return to DSC menu.
• Repeat again to return to the normal operation condition.