37
6
DSC OPERATION
6
■ DSC Set mode
D Add Individual ID/Group ID (See pages 16, 17)
D Delete Individual ID/Group ID (See page 17)
D MMSI Code Check
The programmed 9-digit MMSI (DSC self ID) code can be
checked in DSC Set mode.
q Enter “MMSI Check” in DSC Set up menu.
DSC Menu ➪ Set up ➪ MMSI Check
(Push [MENU]) (Rotate [SELECTOR], then push [ENT].)
w Check the 9-digit MMSI (DSC self ID) code.
--DSC Menu--
MMSI Check
123456789
<CLR˘Exit>
e Push [CLR] to exit the condition to DSC set up menu.
r Push [CLR] or rotate [SELECTOR] to select “Exit,”
push [ENT] to return to the DSC menu.
• Repeat again to return to the normal operation condition.
D Automatic Acknowledgement
This item sets the automatic acknowledgement function to
ON or OFF.
When a position request, position report or polling request
call is received, the transceiver automatically transmits a po
-
sition request reply, position report reply or polling reply call,
respectively.
q Enter “Auto ACK” in DSC menu.
DSC Menu ➪ Set up ➪ Auto ACK
(Push [MENU]) (Rotate [SELECTOR], then push [ENT].)
w Rotate [SELECTOR] to turn the automatic acknowledge-
ment function ON or OFF
.
--DSC Menu--
Auto ACK
ON
˘OFF
<CLR˘Exit / ENT˘OK>
e Push [ENT] to set and to exit the condition to DSC set up
menu.
r Push [CLR] or rotate [SELECTOR] to select “Exit,”
push [ENT] to return to the DSC menu.
• Repeat again to return to the normal operation condition.
To Next Page
Loading...
Need help?
General
