30
8
DSC OPERATION
New2001
■ DSC Task mode (Multiple)
If the Multiple task is enabled, the
transceiver can hold up to 7 tasks.
Therefore, you can make more than 2
DSC calls in parallel. The number of
task is displayed in the Task area.
(Example: After transmitting a Group call)
To use the Multiple task mode, select
“Multiple” in the PROCEDURE menu
(p. 62).
NOTE:
The Task mode has a Time-out
Timer (TOT) function. When you push no key
for a preset period of time, the transceiver
automatically exits the Task mode.
A count down alarm sounds 10 seconds
before the TOT activates.
No count down alarm sounds before Radio
Telephone TOT activates. You can set the
TOT function in the INACTIVITY TIMER
menu. (p. 84)
The default settings of the TOT function:
• Distress call: OFF
• Non-Distress call: 15 minutes
D Software key functions
When entering the Task mode, the
following functions are displayed rst.
FUNCTION
DESCRIPTION
Standby Push to hold the task and
returns to the Main screen.
Delete Push to delete the task and
display the Task list.
Hold Push to hold the task and
display the Task list.
Task List Push to display the Task list.
Resend Push to resend the call.
The following functions may be
displayed, depending on the call type.
FUNCTION
DESCRIPTION
Cancel Push to send a Cancel call.
Pause Push to pause the ‘Call repeat’
mode, or pause the countdown.
Resume Push to resume the countdown.
Finish Push to exit the Distress cancel
statement screen.
History Push to display the Distress call
history screen.
FUNCTION
DESCRIPTION
ACK/
ACK
(Able)
Push to send an
acknowledgment without any
changes.
ACK
(Unable)
Push to send an
acknowledgment, but you
cannot make a communication.
ACK
(New CH)
Send an acknowledgment.
You can specify the Voice
Communication channel.
D Task List
When the number of task is displayed
in the standby mode, you can enter the
task mode by pushing [Task List]
.
L Push [Info] to display the details of
selected task.
(For only the USA version, depending on the presetting.)
To Next Page
Loading...
