Icom iC-M605 - D Receiving a Distress Relay Call

47
8
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
[Ignore]*: Ignores the Call and
returns to the Main screen.
* Displayed only when
“Single” is selected in the
PROCEDURE menu.
(p. 62)
[Hold]: Holds the RX call task, and
returns to the Main screen.
[Pause]:
Pauses the countdown.
• To restart the countdown,
push [Resume] .
[Accept]: Enters the DSC Task
mode.
DSC Task mode (pp. 29, 30)
• Automatically selects Channel 16, and
then you should monitor it, because a
coast station may require assistance.
• Rotate [CH/ENT] to view the call
contents.
4. Push [Standby] to return to
the Main screen.
1. When a Distress Relay call is
received:
• Alarm sounds.
• The following screen is displayed
and the backlight blinks.
• “
” blinks.
2. Push any [Alarm Off] .
3. Select the action.
[Ignore]*: Ignores the Call and
returns to the Main screen.
* Displayed only when
“Single” is selected in the
PROCEDURE menu.
(p. 62)
D Receiving a Distress Relay call
[Hold]: Holds the RX call task, and
returns to the Main screen.
[Pause]: Pauses the countdown.
• To restart the countdown,
push [Resume] .
[Accept]: Enters the DSC Task
mode.
To send the
acknowledgement,
push
[Accept]
.
DSC Task mode (pp. 29, 30)
• Automatically selects Channel 16,
and then monitor it, because a coast
station may require assistance.
• Rotate [CH/ENT] to view the call
contents.
4. Push [Standby] to return to
the Main screen.
TIP: See page 36 for details of
sending acknowledgement.