Icom IC-M92D - DSC Group ID Management; Programming and Naming Group DSC IDs

21
8
DSC OPERATION
Programming Group ID D
Enter “GROUP ID” in the DSC SETTINGS menu. q
 •WhennogroupIDisprogrammed,“NoID”isdisplayed.Inthis
case, push [MENU] to exit the MENU screen.
Push [ADD]. w
 •The“GROUPID”programscreenisdisplayed.
Enter a desired group ID in the following instruction: e
•Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]tosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT].
The first digit is fixed as ‘0’ for a Group ID.
The first two digits are ‘0’ for any Coast station ID.
Repeat step r e to input the specific 9 digits group code.
After entering the 9 digit code, push [ENT] to set it. t
 •GroupIDnameprogrammingscreenisdisplayed.
Enter a desired 10 digit ID name in the following instruction: y
•Selectadesiredcharacterusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]tosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT].
 •Push[123],[!$?]or[ABC]toselectacharactergroup.
After entering the ID name, select “FINISH” pushing [ u Y]/
[Z]/[Ω]/[≈], then push [ENT] to program it.
 •The“GROUPID”listscreenisdisplayed.
Push [MENU] to exit the MENU screen. i
MENU ➪ DSC Settings ➪  Group ID 
(Push [MENU]) (Push [Y]/[Z] , then push [ENT].)