Icom IC-M92D - Group and All Ships DSC Calls; Transmitting Group DSC Calls

31
1
CHAPTER_CONTINUED
Transmitting a Group call D
The Group call function allows you to transmit a DSC signal
to only a specific group.
Enter “GROUP CALL” in the DSC CALLS menu. q
Select the desired preprogrammed group address or w
“Manual Input,” using [Y]/[Z], then push [ENT].
 •TheIDcodefortheGroupcallcanbesetrst.(p.20)
 •When“ManualInput”isselected,setthe8digitIDcodeforthe
group you wish to call.
Select a desired intership channel using [ e Y](CH)/[Z](CH),
then push [ENT].
 •Intershipchannelsarealreadypresetintothetransceiverinthe
recommended order.
About Manual Inputting:
Enter a desired group ID in the following way:
•Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
•Push[ENT]tosetit.
•Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT].
•Therstdigitisspeciedas‘0’foraGroupID.
•Thersttwodigitsare‘0’foranyCoaststationID.
A confirmation screen appears. r
 •Conrmthecallcontents.
MENU
➪ DSC Calls ➪ Group Call
(Push [MENU]) (Push [Y]/[Z] , then push [ENT].)