Icom IC-M92D - Position Request Call Reception; Receiving Position Request DSC Calls

57
8
DSC OPERATION
Receiving a Position Request Call D
When a Position Request Call is received:
➥ The emergency alarm sounds for 2 minutes.
➥ “RCVD POS REQUEST” pops up. The LCD backlight
blinks for 2 minutes.
Push [ALARM OFF] to stop the alarm and the backlight q
blinking.
 •Ifyouhaven’tpushed[ALARMOFF]within2minutes,thenext
screen automatically appears.
Push either softkey to select a desired action. w
[EXIT]
➥Push to ignore the Call and return to the normal operat-
ing mode.
  •ThetransceiverexitstheDSCmode.
  •“ ” continues to blink and the Call is stored in the Re-
ceived Call Log.
[INFO]
➥Push to display the Received call information. (p. 59)
[ACK]
➥ Push to display the “POSITION REPLY” screen and
send a reply to the Call. (p. 39)
When “POSITION ACK” is set to “Auto TX,” the transceiv-
er automatically replies to the Call. In that case, both the
TX and RX calls are stored in the Transmitted and Re-
ceived Call Logs.