Icom IC-M92D - Position and Time Data Programming; Manual Programming of Position and UTC

23
8
DSC OPERATION
A Distress call should include the ship’s position and time
data. If no GPS is connected, your position and UTC (Univer-
sal Time Coordinated) time should be manually input. They
are automatically included when a GPS receiver compatible
with the NMEA0183 ver. 2.0 or 3.01 format is connected.
•ManualprogrammingisdisabledwhenaGPSreceiveris
connected.
•Manuallyprogrammedpositionandtimedatawillbeheld
for only 23.5 hours.
Enter “POSITION INPUT” in the DSC SETTINGS menu. q
Edit your latitude and longitude position data using Dial, or w
[Y]/[Z]/[Ω]/[≈].
 •SelectadesirednumberusingDial,or[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT].
 •SelectN:NorthlatitudeorS:Southlatitudewhenthecursoris
on the ‘N’ or ‘S’ position.
 •SelectW:WestlongitudeorE:Eastlongitudewhenthecursor
is on the ‘W’ or ‘E’ position.
After entering the position data, push [ENT] to program it. e
The UTC time programming screen is displayed, enter the r
UTC time in the following way:
 •Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]tosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT].
Push [ENT] to program your position and time data. t
 •Returntothe“DSCSETTING”screen.
Position and time programming ■
MENU ➪ DSC Settings ➪ Position Input
(Push [MENU]) (Push [Y]/[Z] , then push [ENT].)