Icom IC-M92D - Polling Request Call Reception; Receiving Polling Request DSC Calls

59
8
DSC OPERATION
D Receiving a Polling Request call
When a Polling Request call is received:
➥ The emergency alarm sounds for 2 minutes.
➥ “RCVD POLLING REQUEST” pops up. The LCD backlight
blinks for 2 minutes.
Push [ALARM OFF] to stop the alarm and the backlight q
blinking.
 •Ifyouhaven’tpushed[ALARMOFF]within2minutes,thenext
screen automatically appears.
Push either softkey to select a desired action. w
[EXIT]
➥Push to ignore the Call and return to the normal operat-
ing mode.
  •ThetransceiverexitstheDSCmode.
  •“ ” continues to blink and the Call is stored in the Re-
ceived Call Log.
[INFO]
➥Push to display the Received call information. (p. 58)
[ACK]
➥ Push to display the “POLLING REPLY” screen to reply
to the Call. (p. 43)
When “POSITION ACK” is set to “Auto TX,” the transceiver
automatically replies to the Call. In that case, both the TX
and RX calls are stored in the Transmitted and Received
Call Logs.