Icom IC-M92D - Test Call Reception; Receiving Test DSC Calls

62
8
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D Receiving a Test Call
When a Test Call is received:
➥ The emergency alarm sounds for 2 minutes.
➥ “RCVD TEST CALL” pops up. The LCD backlight blinks for
2 minutes.
Push [ALARM OFF] to stop the alarm and the backlight q
blinking.
 •Ifyouhaven’tpushed[ALARMOFF]within2minutes,thenext
screen automatically appears.
Push either softkey to select a desired action. w
[EXIT]
➥Push to ignore the Call and return to the normal operat-
ing mode.
  •ThetransceiverexitstheDSCmode.
  •“ ” continues to blink and the Call is stored in the Re-
ceived Call Log.
[INFO]
➥Push to display the Received call information. (p. 58)
[ACK]
➥ Push to display the “TEST ACK” screen to reply to the
Call. (p. 37)
When “TEST ACK” is set to “Auto TX,” the transceiver au-
tomatically replies to the Call. In that case, both the TX and
RX calls are stored in the Transmitted and Received Call
Logs.