Icom IC-R20

59
10
SET MODE
DD
CI-V address
To distinguish equipment, each CI-V transceiver/receiver has
its own Icom standard address in hexadecimal code. The IC-
R20’s address is “6C.”
When 2 or more IC-R20s are connected to an optional CT-17
CI - V LEVEL CONVERTOR , set a different address for each IC-
R20 in the range “01” to “7F.” (default: 6C)
DD
CI-V baud rate
Sets the data transfer rate. When “AUTO” is selected, baud
rate is automatically set according to the connected controller
or other Icom CI-V radio. (default: AUTO)
DD
CI-V transceive
CI-V transceive operation is possible with the IC-R20 con-
nected to an Icom CI-V radio. When “ON” is selected, chang-
ing the frequency, operating mode, etc. on the IC-R20
automatically changes those of connected radios and vice
versa. (default: ON)
CI-V-TRANSCEIVE
CI-V-TRANSCEIVE
-ON
>OFF
----------------
>ON
-OFF
----------------
CI-V transceive OFF CI-V transceive ON
CI-V-BAUD-RATE
-1200bps
-300bps
-9600bps
-4800bps
-19200bps
>AUTO
-1200bps
-300bps
>9600bps
-4800bps
-19200bps
-AUTO
----------------
CI-V-BAUD-RATE
----------------
“AUTO” baud rate setting 9600 bps setting
CI-V-ADDRESS
-6C
----------------
CI-V-ADDRESS
-01
----------------
CI-V address set to 6C CI-V address set to 01