18
5
REPEATER OPERATION
■ Offset frequency
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
qPush [A•
FUNC
], then push [8•
SET
] to enter
SET MODE
.
wPush [
YY
] or [
ZZ
] several times until “±” and offset frequency
appear.
eRotate [VOL] to select the desired offset frequency.
• Selectable steps are the same as the pre-set tuning steps.
• The unit of the displayed offset frequency is “MHz.”
rPush [✱•
ENT
] (or [D•
CLR
]) to set the offset frequency
and exit
SET MODE
.
■ Subaudible tones
Some repeaters require subaudible tones to be accessed.
Subaudible tones are added to your normal signal and must
be set in advance.
qPush [A•
FUNC
], then push [8•
SET
] to enter
SET MODE
.
wPush [
YY
] or [
ZZ
] one or more times until “rt” appears.
eRotate [VOL] to select the desired subaudible tone.
rPush [✱•
ENT
] (or [D•
CLR
]) to set the selected tone and
exit
SET MODE
.
• Available subaudible tone frequencies (unit: Hz)
To Next Page
Loading...
