71
13
CLONING
12
13
q Connect the OPC-474
CLONING CABLE
to the [SP] jack of
the master and sub-transceivers.
• The master transceiver is used to send data to the sub-trans-
ceiver.
w While pushing [A•
FUNC
] and [
YY
],
turn power ON to enter cloning
mode (master transceiver only—
power ON for sub-transceiver).
• “CLONE” appears and the transceivers
enter the clone standby condition.
e Push [PTT] on the master trans-
ceiver.
•“CL OU” appears in the master transceiver’s display and S-meter
indicator shows that data is being transferred to the sub-trans-
ceiver.
•“CL IN” appears automatically in the sub-transceiver’s display
and S-meter indicator shows that data is being received from
the master transceiver.
r When cloning is finished, turn power OFF, then ON again
to exit cloning mode.
NOTE: DO NOT push [PTT] on the sub-transceiver during
cloning. This will cause a cloning error.
Cloning allows you to quickly and easily transfer the pro-
grammed contents from one transceiver to another trans-
ceiver.
■ Transceiver-to-transceiver cloning
AT
POWER ON
To Next Page
Loading...
