Icom IC-V82 - Memory Bank Selection; Memory Bank Setting

25
6
MEMORY/CALL OPERATION
6
■ Memory bank selection
The IC-V82/U82 has a total of 10 banks (A to J). Each mem-
ory channel, 0 to 199, may be assigned to one of the banks
for easy memory management.
q Push [C•
MR ] to select memory mode.
w Push [A•
FUNC ] and [#• BANK ] to enter
memory bank selection.
• Bank indicator blinks.
e Rotate [VOL] to select the desired
bank, A to J.
• Banks that have no programmed con-
tents are skipped.
r Push [✱• ENT ] (or [D• CLR ]) to se-
lect the bank.
• Indicator stops blinking.
t Push [
YY
] or [
ZZ
] to select the channel in the bank.
• No channel numbers are displayed for memory bank operation.
y To return to regular memory condition, push [A• FUNC ] and
[#•
BANK ] to enter memory bank mode, then push
[✱•
ENT ] (or [D• CLR ]).
■ Memory bank setting
q Push [C• MR ] to select memory mode, then select the de-
sired memory channel via [
YY
] or [
ZZ
].
w Push [A•
FUNC ] and [8• SET ] to enter
SET MODE .
e Push [
YY
] or [
ZZ
] several times until
“bAk” appears.
• “– –” indication blinks as follows.
r Rotate [VOL] to select the desired
bank.
t Push [✱• ENT ] (or [D• CLR ]) to assign the channel to the
bank and return to regular memory condition.
y Repeat steps q to t to assign another memory channel
to the same or another bank.
NOTE: Display type setting (pgs. 16, 65) in
INITIAL SET
MODE
must be selected “FR,” otherwise the memory bank
operation cannot be performed.
[VOL]
ENT
FUNC
A
SET
8
MR
C
Push
[VOL]
ENT
FUNC
A
BANK
MR
C
Push