21
6
MEMORY/CALL OPERATION
6
5
■ Selecting a memory channel
qPush [C•
MR
] to select memory mode.
•“
X
” appears.
wEnter 2 digits to select the desired memory channel (or
push the [
YY
]/[
ZZ
] keys).
• The memory channels 0–9 are proceeded by a “0.”
• When [VOL] is assigned as tuning dial, rotate [VOL] to select
the memory channel. (pgs. 14, 65)
■ Selecting the call channel
➥ Push [B•
CALL
] to select the call channel.
• “C” is displayed instead of the memory channel number.
• Push [D•
CLR
] or [C•
MR
] to select VFO or memory mode, respec-
tively.
The transceiver has 207 memory channels including 6 scan
edge memory channels (3 pairs), and 1 call channel. Each
of these channels can be individually programmed with op-
erating frequency (pgs. 13, 14), duplex direction (p. 17) and
offset (p. 18), subaudible tone encoder or tone squelch and
its tone frequency (pgs. 18, 35) and skip information* (p. 32).
*except for scan edge memory channels.
In addition, a total of 10 memory banks, A to J, are available
for usage by group, etc.
■ General description
To Next Page
