23
6
MEMORY/CALL OPERATION
6
■ Channel name programming
qSelect a “Channel Name Indication” type in
INITIAL SET
MODE
(p. 65).
wPush [C•
MR
] to select memory
mode, if necessary.
ePush [A•
FUNC
], then push [8•
SET
]
to enter into the channel name
programming mode.
• The character to be edited blinks.
rRotate [VOL] to select a charac-
ter.
tPush [
YY
] to move the cursor to right, [
ZZ
] to move the cur-
sor to left.
• Up to 5 characters can be used for channel name.
• Usable characters are A–Z, 0–9, “space,” +, –, =, ✱, /, [, ] and :.
y Push [✱•
ENT
] (or [D•
CLR
]) to set the name and exit the
channel name programming mode.
■ Memory transfers
This function transfers a memory channel’s contents to VFO
(or another memory/call channel). This is useful when search-
ing for signals around a memory channel frequency and for
recalling the offset frequency, subaudible tone frequency etc.
D Memory/call ➾ VFO
qSelect the memory (call) channel
to be transferred:
➥ Push [C•
MR
] (or [B•
CALL
]) to
select memory (call) mode.
➥ Push [
YY
] or [
ZZ
] to select the
memory channel.
• When [VOL] is assigned as tuning
dial, rotate [VOL] to select the
memory channel. (pgs. 14, 65)
wPush [A•
FUNC
], then push and
hold [C•
MR
] for 1 sec. to transfer
the selected memory contents to
the VFO.
• VFO mode is selected automatically.
To Next Page
