Icom IC-V82 - CPU Reset; Partial Reset

70
12
OTHER FUNCTIONS
■ CPU reset
The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
•Partial resetting is also available. See right for details.
IMPORTANT!:
Resetting the transceiver CLEARS all memory information
and initializes all values in the transceiver.
➥ While pushing [MONI] and [D•
CLR ],
push and hold [PWR] for 1 sec. to
reset the CPU.
• “CLEAR” indicates, then initial display
appears.
■ Partial reset
If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents, a partial resetting function is available
for the transceiver.
➥ While pushing [D•
CLR ], push and
hold [PWR] for 1 sec. to partially
reset.
AT POWER ON AT POWER ON
PWR
MONI
CLR
D
PWR
CLR
D