44
11
DIGITAL MODE OPERATION
DD
Station call sign programming
Station call sign must be programmed for the specified sta-
tion call as well as repeater operation in both digital voice and
low-speed data communications.
q Push [A•
FUNC
] and [0•
OPT
] to enter
OPTION SET MODE
, then
push [
YY
] or [
ZZ
] several times to select the call sign select
mode.
• “yUC” appears for station call sign.
w Push and hold [0•
OPT
] for 1 sec. then rotate [VOL] to se-
lect the desired call sign channel.
e Push [
YY
] to select call sign programming mode.
• The 1st digit blinks and channel indication stops blinking.
r Rotate [VOL] to select the desired character or code.
• Push [
ZZ
] or [
YY
] to move the cursor to left or right, respectively.
t Push [
YY
] to select 2nd digit, then rotate [VOL] to select
the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming station call sign.
y Push [0•
OPT
] to save the call sign.
u Rotate [VOL] to select an another channel from “C1” to
“C6.”
i Repeat steps w to u to program another station call sign
channels.
✔
For your information:
Station and/or repeater call sign can be programmed from
Received call record when a call is received.
See page 46 for details.
To Next Page
Loading...
