WindO/I-NV4 User’s Manual 14-41
4 Using the Data
14
Data Log Function
6 Click the Options tab.
7 Select the Copy Data Log Data check box.
8 Specify the destination device address for the copied data in Destination Device Address.
You can only specify an internal device.
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-68.
9 Select the data that is the start point for copying data in Starting Point.
■ Newest Data
Set the starting point to read as the newest data.
■ Oldest Data
Set the starting point to read as the oldest data.
■ Specify by Value of Device Address
Specifies which data from the oldest data to set as the starting point to read by value of device address, and sets that
data as the starting point to read.
Specifies the source device address. You can only specify an internal device.
Click to display the Tag Editor. For the device address configuration procedure, refer to Chapter 2 “5.1 Device
Address Settings” on page 2-68.
To Next Page
Loading...
Need help?
General
