WindO/I-NV4 User’s Manual 3-7
4 No External Devices
3
Communication
4.1 Overview
In this case, there is no communication with an external device, so the MICRO/I operates as a standalone unit.
It is only possible to operate the MICRO/I with relays and registers.
4.2 No External Devices Settings
No external devices settings are selected on the Select Communication Driver dialog box, or the Communication
Driver tab on the Project Settings dialog box.
• When creating new project data by following displayed dialog boxes and configuring settings step by step, by
clicking , and then clicking New, the Select Communication Driver dialog box is displayed. For details, refer
to Chapter 4 “Create new project data by using the interactive quick start” on page 4-1.
•Click Communication Driver on the status bar to display the Communication Driver tab on the Project
Settings dialog box. For details, refer to Chapter 4 “Changing Communication Drivers” on page 4-21.
Select No External Devices in Manufacturer.
4 No External Devices
HG3G
HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T
HG4G HG1G HG1P
MICRO/I
Internal device
No external device
To Next Page
Loading...
Need help?
General
