4 E-mail Function
28-48 WindO/I-NV4 User’s Manual
11
Select the e-mail address or the E-mail Group as the destination, and then click >> under the To.
Set Cc and Bcc in the same procedure with To as necessary.
12
Click OK to close the E-mail Address Book dialog box.
You are returned to the E-mail Settings dialog box.
13
Enter Subject.
14
Enter (Body).
15
Repeat steps 2 through
14
to configure the necessary e-mails.
• To attach the screenshots, the Alarm Log files, the Data Log files and the Operation Log files to an e-mail, configure
them in the Attach Files dialog box displayed by clicking Attach Files. For details, refer to “Attach Files Dialog Box”
on page 28-62.
• To insert the value of the device address in the body text of the e-mail, configure it in the Insert Value of Device
Address dialog box displayed by clicking Insert Value of Device Address. For details, refer to “Insert Value of
Device Address Dialog Box” on page 28-64.
16
Click OK to close the E-mail Settings dialog box.
This concludes configuring the e-mail.
To select multiple e-mail addresses or E-mail Groups, press and hold SHIFT or CTRL while you click the
specific items.
To Next Page
Loading...
Need help?
General
