FC6A S
ERIES
M
ICRO
S
MART
A
LL
-
IN
-O
NE
T
YPE
U
SER
’
S
M
ANUAL
FC9Y-B1722 3-27
3: I
NSTALLATION
AND
W
IRING
Removing the SD Memory Card
1. Unlock and open the SD memory card cover.
For details, see "Opening the SD Memory Card Cover" on page 3-25.
2. Push the SD memory card inserted into the FC6A Series MicroSmart until it clicks to unlock it.
3. Slowly pull out the SD memory card.
4. Close the SD memory card cover and push it until it clicks.
For details, see "Closing the SD Memory Card Cover" on page 3-26.
The data on the SD memory card may be corrupted by doing the following during access to the SD memory card.
• Turning the FC6A Series MicroSmart power OFF.
• Removing the SD memory card.
Do not turn OFF the FC6A Series MicroSmart power during access to the SD memory card (while the SD card status LED
"SD" is flashing). First confirm that the SD card status LED "SD" is not flashing, then remove the SD memory card from
FC6A Series MicroSmart. For details on the SD card status LED "SD", see "SD Memory Card" on page 11-1.
To Next Page
Loading...
Need help?
General