FC6A S
ERIES
M
ICRO
S
MART
A
LL
-
IN
-O
NE
T
YPE
U
SER
’
S
M
ANUAL
FC9Y-B1722 2-13
2: P
RODUCT
S
PECIFICATIONS
Self-diagnostic Functions
Input Filter
0 ms (without filter), 3 to 15 ms selectable (in 1 ms increments)
Catch Input/Interrupt Input
High-speed Counter
Pulse Output (Transistor Output Type Only)
Function Switch
Run/Stop Methods
• Keep data
• User program sum check (EEPROM)
• User program sum check (RAM)
• Timer/counter preset value sum check
• User program syntax check
• User program execution check
• WDT check
• User program write check
• Power failure
• Clock error
• Data link connection check
• I/O bus initialization check
High-speed 4 Points (I0, I1, I6, I7)
Minimum turn on pulse width: 5 μs
Minimum turn off pulse width: 5 μs
Medium-speed 2 Points (I3, I4)
Minimum turn on pulse width: 35 μs
Minimum turn off pulse width: 35 μs
Maximum Counter
Frequency and Points
Single-phase, two-phase common: 100 kHz (single-phase 4 points max, two-phase 2 points max)
Single-phase dedicated: 5 kHz (2 points)
Count Range
Single-phase, two-phase common: 0 to 4,294,967,295 (32 bits)
Single-phase dedicated: 0 to 4,294,967,295 (32 bits)
Operation Mode Rotary encoder mode, adding counter mode, frequency measurement mode
Type No.
FC6A-C16K1CE
FC6A-C16P1CE
FC6A-C24K1CE
FC6A-C24P1CE
FC6A-C40K1CE
FC6A-C40P1CE
FC6A-C40K1DE
FC6A-C40P1DE
FC6A-C40K1CEJ
FC6A-C40P1CEJ
FC6A-C40K1DEJ
FC6A-C40P1DEJ
Points
High-speed Output (100 kHz) 2 (however, CW/CCW is 1 axis)
4 (however, CW/
CCW is 4 axes)
Medium-speed Output (5 kHz) 2 (however, CW/CCW is 1 axis) ―
Points 1 (2 position slide button)
Function
Program run/stop
The function can be set in the function area settings (default setting: enabled).
• Power on/off
• WindLDR RUN/STOP command
• Function switch operation
• Special internal relay (M8000) operation
• Operation of the set inputs with the stop and reset input terminals
To Next Page
Loading...