Ikegami BS-98 - Page 76

62
BS-98 1409 VER1 (U) (E)
5.1 Settings from the BS Menu
MIC MANAGEMENT
Return to a main menu screen.
HD SYS EMBEDDED ALL ON/OFF Set whether to embed audio signal to all HDTV output.
HD OUT-1 ON/OFF Set whether to embed audio signal to HDTV OUT-1 output.
HD OUT-2 ON/OFF SSet whether to embed audio signal to HDTV OUT-2 output.
HD OUT-3 ON/OFF Set whether to embed audio signal to HDTV OUT-3 output.
HD PM ON/OFF Set whether to embed audio signal to HDTV PM OUT output.
SD SYS EMBEDDED ALL ON/OFF Set whether to embed audio signal to all SDTV output.
SD SDI ON/OFF Set whether to embed audio signal to SDTV OUT-3 output.
SD PM ON/OFF Set whether to embed audio signal to SDTV PM OUT output.
MASTER DELAY Sets the audio delay for all systems
HD SYS DELAY Sets the audio delay for HDTV systems
SD SYS DELAY Sets the audio delay for SDTV systems
DIGITAL DELAY Sets the audio delay for digital audio output
MIC1/2 OUT DELAY Sets the audio delay for analog audio output
MIC1 OUTPUT LEVEL Set the output reference level of MIC1 OUT (0dB/4dB)
MIC1 LVL ADJ (0dB) Set the level 0dB setting of MIC1 OUT
MIC1 LVL ADJ (4dB) Set the level 4dB setting of MIC1 OUT
MIC2 OUTPUT LEVEL Set the output reference level of MIC2 OUT (0dB/4dB)
MIC2 LVL ADJ (0dB) Set the level 0dB setting of MIC2 OUT
MIC2 LVL ADJ (4dB) Set the level 4dB setting of MIC2 OUT
MIC1 CENTER ADJ Center OFFSET adjustment of MIC1 GAIN REMOTE external control voltage
MIC2 CENTER ADJ Center OFFSET adjustment of MIC2 GAIN REMOTE external control voltage
INCOM MANAGEMENT
Return to a main menu screen.
ENG IF Selection of the for ENG-line system interface 4W/RTS/Cler-Com.
ENG-INPUT TERM Selection of the input termination 600

/10K

of the ENG-line system interface.
ENG-OUTPUT LOAD Termination setup for ENG-line RTS/Cler-Com system
PROD IF Selection of the PROD-line system interface 4W/RTS/Cler-Com.
PROD-INPUT TERM Selection of the input termination 600

/10K

of the PROD-line system interface.
PROD-OUTPUT LOAD Termination setup for PROD-line RTS/Cler-Com system
ENG-PROD 2LINE/1LINE To choose whether to 1-line or 2-lines to the system line
FRONT INCOM
Select the type of headset microphone to be connected to the front of the connector.
MIC POWER SUPPLY Set whether or not to microphone power the ECM setting
PGM1 TERM Select the line termination 600/10K

of PGM1
PGM1 INPUT LEVEL Select the Input level -20dB/0dB/4dB of PGM1