ILX Lightwave LDC-3700 Series User Manual

Front Panel LASer :COND?
Remote
The LASer:COND?
query returns the value of the status condition register of the LASER operations.
SYNTAX DIAGRAM
LAS COND
PARAMETERS None. The response will be in the form:
-where the response is the
sum of the following:
1 - LASER Current Limit
2 - LASER Voltage Limit
4 - NIA
8 - Power limit
16
- Interlock disabled
32 - NIA
64 - N/A
128 - Open circuit
256 - Output is shorted
512 - Output is outside tolerance limit
1024 - Output onloff state
2048 - Ready for calibration data state
40% - Calculation error
8 192 - Error communicating with LASER board
16384 - SoAware error in LASER control
32768 - LASER eeprom checksum error
POINTS OF
INTEREST The LASER conditions which are reported to the status byte are set via the
LASer:ENABle:COND command.
The Open circuit condition
is only present while the LASER output is on, and when the
hardware detects this condition, it will turn the LASER output off. Therefore, the Open
Circuit condition is
fleeting and may be mid via the LAS:COND? query. Therefore, the
user should test for the Open Circuit Event
via the LASEVEnt? query.
The LASER condition
status is constantly changing, while the event status is only cleared
when the event
status is read or the *CLS command is issued.
EXAMPLES
"LAS:COND?" -response: 513, means that the LASER limit current and out of tolerance
LASER conditions currently exist.
"Radix Hex; Laser:Cond?"
-response: #H108, means that the LASER Output shorted and
Power limit conditions currently exist.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English