ILX Lightwave LDC-3700 Series User Manual

LDC-3700 Series DEVICE-DEPENDENT COMMANDS
NAME
BEEP
BEEP?
DELAY
ERR?
LAS
: CALMD
LAS: CALMD?
LAS:CAL:LDI
LAS:CAL:LDI?
LAS:DIS
LAS:DIS?
LAS:DIS:LDI
LAS:DIS:LDI?
LAS:DIS:MDI
LAS:DIS:MDI?
LAS:DIS:MDP
LAS:DIS:MDP?
LAS :DIS:PARAM
LAS:DIS:SET
LAS:DIS: SET?
LAS:ENAB:COND
LAS:ENAB:COND?
LAS:ENAB:EVE
LAS:ENAB:EVE?
LAS:ENAB:OUTOFF
NUMBER OF FUNCTION
PARAMETERS
EXPECTED
1
NONE
1
NONE
1
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
0, 1 or 2
1
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
1
NONE
1
NONE
1
NONE
NONE
0, 1 or 2
1
Enables/disables the beeper, or beeps once.
Returns the enable
status of the beeper.
Used to create a delay in the execution of further commands.
Returns errors generated since the last query.
Used to set the CAL PD (monitor responsivity) constant.
Returns the CAL PD (monitor responsivity) constant.
Used to enter the constant I calibration mode.
Returns the
ready state for entering the constant I calibration
value.
Used to enter the laser voltage calibration mode.
Returns the
ready state for entering the laser voltage
calibration value.
Used to enter the monitor photodiode feedback current
calibration mode.
Returns the ready state for entering the monitor PD current
calibration value.
Returns the value of the LAS condition register.
Used with LAS:STEP command to decrement the set point
value by one or more
steps.
Turns the LAS display on or off.
Returns the LAS display
value.
Turn odoff LAS display to show output current.
Returns odoff
status of DIS I switch.
Turn odoff display to show PD monitor current.
Returns odoff
status of DIS IPD switch.
Turns odoff &splay to show PD monitor power.
Returns odoff status of DIS PPD switch.
Enables Display to show parameter values.
Same action
as setting LAS DIS SET switch.
Returns odoff
status of LAS DIS SET switch.
Sets the enable register for LAS conditions.
Returns the value of the LAS conditions enable register.
Sets the enable register for LAS events.
Retm the value of the LAS event enable register.
Sets the enable regster for LAS conditions which
turn the
LAS output off.
Returns the value of the LAS outoff enable register.
Returns the value of the LAS event register.
Used with LAS STEP command to increment the LAS set
point value
by one or more steps.
Used to set the LAS constant current source set point value.
Table
4.2 LDC-3700 Series Device-Dependent Commands
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English