ILX Lightwave LDC-3700 Series User Manual

LDC-3700 Series DEVICEDEPENDENT COMMANDS (CONT.1
NAME
LAS :RAN?
LAS:SET:LDI?
LAS: SET:MDI?
LAS
: STEP?
LAS :TOL
MES
MES?
RAD
RAD?
SECURE
NUMBER OF
PARAMETERS
EXPECTED
1
NONE
NONE
NONE
NONE
1
NONE
2
NONE
1
NONE
1
NONE
NONE
NONE
NONE
NONE
NONE
1-3
NONE
FUNCTION
Sets the LDC-3700 Series Laser Diode Controller's current
output range.
Returns the LDC-3700 Series Laser Diode Controller's current
output range.
Returns the constant I (current)
set point.
Returns the constant optical power
set point, if the PD
responsivity is 0.
Returns the constant P (optical power) set point,
if the PD
responsivity
is non-zero.
Used to
set the LAS step value for use with DEC or INC
commands. Defaults to a step of 1; 1 step is equal to the
display resolution for the parameter, i.e.
1 uA for Ipd.
Range is 1 - 9999 steps.
Returns the LAS step value.
Used to set the LAS set point tolerance value and time period
value for validation,
i.e.
used to determine if a set point
has been reached - must be within tolerance for the time
period.
Used to return the LAS set point tolerance value and time
period value for validation, i.e.
used to determine if a set
point has been reached -must be within tolerance for the
time period.
Used to enter a string message of up to
16 bits.
Returns a previously stored ASCII message.
Used to set the
radix type for numerical data. Decimal, binary,
octal, and hexadecimal are allowed.
Used to return the
radix type for numerical data. Decimal,
binary, octal, and hexadecimal are allowed.
To
be used by authorized service personnel only, to gain access
to protected data.
Used to enter the TEC current source calibration mode.
Returns the ready state for entering a current source calibration
value.
Used to enter the sensor calibration mode; sensor
type depends
on rear panel sensor switch setting.
Returns the ready state for entering a sensor calibration value.
Returns the value of the
TEC condition register.
Used to enter the Steinhart-Hart constants for R-T conversion.
Also used to enter constants for AD590 and
LM335.
Used to read back the Steinhart-Hart constants for R-T
conversion. Also used to read back constants for AD590
and LM335.
Table
4.2 LDC-3700 Series Laser Diode Controller Device-Dependent Commands (Cont)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English